Intelligent Fire Alarm Peripheral Devices
Ten-Input Monitor Module
- Product’s code: XP10-M(A)
- Brand: Notifier
- Guarantee: 1 Year
- Status: 1
- Price: Please contact us!
- Promotion Price: Please contact us!
- Product’s Introduction
- Specifications
- CATALOG
- Accessories
The
XP10-M ten-input monitor module is an interface between a control panel and normally open contact devices in intelligent alarm systems such as pull stations, security contacts, or flow switches.The first address on the
XP10-M is set from 01 to 150 and the remaining modules are automatically assigned to the next nine higher addresses. Provisions are included for dis- abling a maximum of two unused addresses.The supervised state (normal, open, or short) of the moni- tored device is sent back to the panel. A common SLC input is used for all modules, and the initiating device loops share a common supervisory supply and ground — otherwise each monitor operates independently from the others.
Each
XP10-M module haspanel-controlled green LED indi- cators. The panel can cause the LEDs to blink, latch on, or latch off.NOTE: Unless otherwise specified, the term
XP10-M is used in this data sheet to refer to both theXP10-M and theXP10-MA (ULC-listed version).Standby current: 3.5 mA (SLC current draw with all addresses used; if someaddresses are disabled, the standby current decreases).
Alarm current: 55 mA (assumes all tenLEDs solid ON).
Temperature range: 32°F to 120°F (0°C to 49°C) for UL applications;
–10°C to +55°C for EN54 applications.Humidity: 10% to 85% noncondensingfor UL applications; 10% to 93% noncondensing for EN54 applications.
Dimensions: 6.8" (172.72 mm)high x 5.8" (147.32 mm) wide x 1.25" (31.75 mm) deep.
Shipping weight: 0.76 lb. (0.345 kg) including packaging.
Mounting options:
–
CHS-6 chassis: Up to 6 modules.–
BB-25 cabinet: Up to 6 modules.–
BB-XP cabinet: One or two modules.–
CAB-4 Series cabinet: SeeDN-6857. –EQ CabinetSeries: See
DN-60229. Wire gauge: 12 AWG (3.31 mm²) to 18AWG (0.821 mm²).
Power-limited circuits must employ type FPL,FPLR, or FPLP cable as required by Article 760 of the NEC.XP10-M isshipped in Class B position;remove shunt for Class A operation.Maximum SLC wiring resistance: 40 or 50 ohms, panel dependent.
Maximum IDC wiring resistance: 1500 ohms.
Maximum IDC voltage: 10.2 VDC.
Maximum IDC current: 240 µA.
Other Products
Six Relay Control Module 
Addressable Pull Station 
Control and Relay Modules 
Monitor Modules with FlashScan 
Very Intelligent Early Warning - Laser Smoke Detector 
Acclimate® Plus™ Multi-Sensor Low-Profile Intelligent Detector 
Intelligent plug-in thermal detectors with integral communication 
Intelligent Plug-In Photoelectric Smoke Detectors with FlashScan
